It only takes 1 min to finish flashing, and this is the output I get. (You will need to modify it according to your setup) D:flashtoollibavrdudewindows>avrdude -P COM4 -b 19200 -c arduino -p ATmega88 P -v -e -U flash:w:"D:EOSD_customcl-osd.hex":i Once downloaded the firmware, connected wires, open up a CMD window, and use command similar to this. The way to flash the e-osd, is the same way as flashing the KK2. I then connect it to the Arduino, according to this diagram. I just soldered some female jumper headers to them. This OSD provides programing pins and it’s easy to access. OSD is an useful device that overlays flight information on your FPV screen. Please read our Affiliate Link Policy for more information. This helps support the free content for the community on this website. I receive a commission (at no extra cost to you) if you make a purchase after clicking on one of these affiliate links. Some of the links on this page are affiliate links.
0 kommentar(er)
